| |
| |
Model
No. F4011 Assembly Instructions
|
| |
|
Step
1 Preperation |
- Spread your tent on level ground and pull out the four corners.
- Open the window flaps. This will allow air into the tent during
assembly.
|
| |
 |
Step
2 Pole Assembly |
- Assemble all the shock-corded poles. You will have 2 sets
of long poles and 1 set of short poles.
- Slide the two long poles through the center sleeves diagonally
so that the frames form an "X"
|
| |
|
Step
3 Tent Erection |
- Place one end of the pole into a pin located on a corner of
the tent floor.
- Flex the fiberglass pole by pushing the other end upward to
make an arch.
- Secure it by placing the end into a pin on the other corner
of the tent floor.
- Repeat this procedure for the other pole.
- Attach the tent clips to the poles along the tent pole lines.
|
| |
|
Step
4 Rain Fly |
- Insert the ends of the short pole into the pole pockets of
your rain fly.
- Tie the center of the pole with the center tie.
- Place the rain fly over the tent and tape the Velcro around
the tent poles. Velcros are located inside the tent fly along
the tent pole lines.
- Attach the S-hooks from tent fly to the rings located on the
tent corner.
- Attach the clips from the roof of your tent to the fly pole.
- Even when you don't use the rain fly, place the fly pole over
the tent and attach the clips from the roof of your tent to
the fly pole.This will maintain more headroom in your tent.
CAUTION: If you use your tent without
the rain fly, make sure to flip over both end sections of the
fly pole (roof pole) and secure them with rubber bands. The excess
parts of the fly pole (roof pole) may cause injury.
|
| |
|
Step
5 Stake |
- Stake down the 4 corners first.
- Take a free end of the guy rope and tie the rope to the webbing
loop on one side of the rain fly.
- Guy out the rope straight at a 45-degree angle. Stake it out
and adjust the rope with a stopper. Repeat this procedure for
the other side of the rain fly.
|
