| |
| |
Model
No.F4160 Assembly Instructions
|
| |
|
Step
1 Preperation |
- Spread your tent on level ground and pull out the four corners.
- Open the window flaps. This will allow air into the tent during
assembly.
|
| |
|
Step
2 Pole Assembly |
- Assemble all the shock-corded poles. You will have 2 sets
of long poles and 1 set of short poles.
- Place the 2 long poles over the tent from corner to corner
diagonally so that the frames form an "X"
|
| |
|
Step
3 Tent Erection |
- Secure each end of a pole into a pin located on each corner
of the tent floor.The poles will form arches.
- Starting from ground level, attach the tent clips to the poles
along the tent pole lines.
- Repeat this procedure for the other pole.
|
| |
 |
Step
4 Rain Fly |
- Insert the ends of the short pole into the pole pockets of
your rain fly.
- Tie the center of the pole with the center tie.
- Place the rain fly over the tent and tape the Velcro around
the tent poles. Velcros are located inside the tent fly along
the tent pole lines.
- Attach the S-hooks fro the rain fly to the rings on the tent
corner.
- Attach the clips from the roof of your tent to the fly pole.
- Even when you don't use the rain fly, place the fly pole over
the tent and attach the clips from the roof of your tent to
the fly pole.This will maintain more headroom in your tent.
CAUTION: If you use your tent without
the rain fly, make sure to flip over both end sections of the
fly pole (roof pole) and secure them with rubber bands. The excess
parts of the fly pole (roof pole) may cause injury.
|
| |
Step
5 Stake |
- Stake down the 4 corners of the tent first. And stake the
other loop on the floor.
- Stake down the intermediate loops on the fly.
- Stake down the front end of the fly to form a gear room.
- Take a free end of the guy rope and tie the rope to the webbing
loop on one side of the rain fly.
- Guy out the rope straight at a 45-degree angle. Stake it out
and adjust the rope with a stopper.
- Repeat this procedure for the other side of the rain fly.
|
